FN
STAPLER UNIT
(5) Detach the connector from the clincher you wish
Caution:
to replace, and remove the four set screws hold-
3DIS./ASSEMBLY1DIS./ASSEMBLYWhen disassembling and reassembling
ing the clincher in place.
the machine, Be sure the power cord has
been unplugged from the wall outlet.Screws
[1] Exchanging the clincher (FN-7 only)
a. Procedure
(1) Remove the front cover.
(2) Pull out the stacker/stapler unit by pulling on the
handle.
(3) Remove the two rail-stopper set screws.
Rail stopper screw
Connector
Connector
(6) Lift the clincher up and out.
Clincher
Stacker/stapler unit
Rail stopper screw
(4) Remove four set screws holding the cover in
place, and remove the cover.
(7) To install the new clincher, carry out the aboveScrews
sequence in reverse.
(8) Adjust the stapler vertical positioning.
Cover
Screws
1-R-10 |